What you’ll explore
How far can it lean before it falls? What if it’s taller? In this lab you tilt a tall box until it tips and test your intuition against a real physics simulation.
Challenge levels
- Tipping point. A uniform box is 0.4 m wide and 1.2 m tall. Tilt it onto one edge: at what angle does it stop coming back, in degrees?
- Let go at 20°. Same box, tilted 20° and released. Where does it end up: 0 (back on its base) or 90 (on its side)?
- Weight it down. This box is tilted 28° — well past 18.4°. Move mass into a heavy base layer (the bottom 10% of the box) until it comes back when released.
- What if it’s taller?. What if the box is twice as tall (2.4 m) but just as wide? At what angle does it tip now, in degrees?
- Widen the base. A 1.2 m tall uniform box is tilted 25° and released. Make it wide enough that it comes back.
Key ideas
Show the explanations (spoilers: try the levels first)
- The center of gravity is 0.2 m in from the edge and 0.6 m up. It passes over the edge at tan θ = 0.2 ÷ 0.6, so θ ≈ 18.4°.
- At 20° the center of gravity is already past the edge, so gravity’s torque tips it the rest of the way.
- A heavy base pulls the center of gravity down, so it has to lean further before it passes the edge. You need about 41% of the mass in the base.
- Its center of gravity is twice as high, so tan θ = 0.2 ÷ 1.2 and θ ≈ 9.5°. Tall, narrow things tip easily.
- It comes back while tan 25° < w ÷ h, so the width must be more than 1.2 × tan 25° ≈ 0.56 m.
About the model
- The box is a rigid rectangle pivoting about one bottom edge that never slips; it is released from rest at the chosen tilt. g = 9.81 m/s²; air resistance ignored.
- Heavy base: a share f of the mass sits in a dense layer filling the bottom 10% of the box, so the CG height is h·(0.5 − 0.45·f). The CG stays on the center line (w/2 from each edge).
- Motion: I·θ″ = M·g·r·sin(θ − θc), with I = Σ m(w² + H²)/3 for each part about the pivot edge. Integrated with RK4 (1 ms grid); the run ends exactly when it lands back on its base (0°) or on its side (90°). The landing bounce is not simulated.
- Mass cancels out of the motion; only the shape and the mass distribution matter.
- Leaning Tower of Pisa (long video): it leans about 4° (3.97° after the 1990–2001 stabilisation) and its CG line stays inside its base. Its real danger was the soft soil under the foundation, not rigid toppling — the rigid-box model says nothing about soil.
- The CG marker, plumb line and angle arc are drawn in front of the box for visibility.
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.