What you’ll explore
How many containers before the barge sinks? In this lab you load cargo into a barge until the waterline hits the Plimsoll line and test your intuition against a real physics simulation.
Challenge levels
- Four containers. The empty barge (12 t, 10 m × 4 m deck) floats in a river. You load four 5-metric ton containers. How deep does its bottom sit below the water once it settles, in m?
- How many before it sinks?. Keep adding 5-metric ton containers. How many can the barge (2 m deep hull) carry and still float? The next one swamps it.
- Load to the line. The Plimsoll “FW” mark says the barge may sit at most 1.50 m deep in fresh water. Load cargo so it settles right on the mark (within 2 cm).
- Out to sea. What if the barge, loaded to its fresh-water mark (48 t of cargo), sails out into sea water (1025 kg/m³)? How deep does it sit now, in m?
Key ideas
Show the explanations (spoilers: try the levels first)
- It sinks until the water it pushes aside weighs as much as barge + cargo: 32,000 kg ÷ (1000 kg/m³ × 40 m²) = 0.80 m.
- Fully down to its deck, the hull pushes aside 10 × 4 × 2 = 80 m³ of water = 80 t. Minus the 12 t hull leaves 68 t for cargo: 13 full containers. The 14th (70 t) brings the deck under water.
- Draft 1.50 m means 1.50 × 40 = 60 m³ of water pushed aside = 60 t. Minus the 12 t hull: 48 t of cargo.
- Same 60 t, but now 60,000 ÷ (1025 × 40) = 1.463 m: it rides 3.7 cm higher. That’s why a ship’s Plimsoll marks put the fresh-water line above the sea line.
About the model
- The barge is a sealed rectangular box, 10 m long, 4 m wide and 2 m deep, with an empty mass of 12 t. Its sides are vertical, so the water it pushes aside is 40 m² × draft, and buoyancy = ρ·g·40·draft (Archimedes).
- Vertical motion only (no pitch, roll or waves). The hull heaves as a damped oscillator about the Archimedes draft, with damping ratio 0.3 and a fixed added mass of 0.25·ρ·A·W for the water that moves with it; these set how it bobs, not where it settles.
- Containers weigh 5 t each and are set down gently at rest (no drop); each landing shares the heave momentum with the new mass. Loads sit evenly, so the barge stays level. Container boxes are drawn smaller than real 20-ft boxes to fit the deck.
- The barge counts as swamped the moment its deck edge reaches the water (freeboard 0): in reality water would pour over the deck and it would go down. Heavy lifts set down quickly can overshoot and swamp it below the static limit.
- Plimsoll marks: FW = 1.50 m, the deepest safe draft in fresh water (1000 kg/m³); S = 1.50 × 1000 ÷ 1025 ≈ 1.46 m, the same load in sea water (1025 kg/m³). Real load lines also include a safety margin and seasonal marks.
- Arrows: buoyancy up (teal), weight down (red), drawn from the hull center at the same scale; they match once the hull settles.
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.