What you’ll explore
Can 200 newtons lift a 1,500 kg car? In this lab you lift a car with one hand using a hydraulic jack and test your intuition against a real physics simulation.
Challenge levels
- How hard to push?. A 1,500 kg car sits on the big piston (20 cm across). The pump piston is 2.5 cm across. What steady push on the pump piston lifts the car, in N?
- How far to push?. Same jack. To raise the car 10 cm, how far must the pump piston travel in total (all pumps added up), in m?
- Pick the pump. Lift the 1,500 kg car 10 cm with a 16 cm big piston and 15 cm pumps. Your arm manages at most 200 N, and you have patience for at most 60 pumps. Choose the pump piston size.
- What if the big piston doubles?. Rebuild the jack with a big piston of TWICE the area (same 2.5 cm pump, same car). What push is needed now, in N?
- No free energy. With the original jack (2.5 cm pump, 20 cm ram), how much work does your hand do to raise the car 10 cm, in J?
Key ideas
Show the explanations (spoilers: try the levels first)
- Areas go with diameter squared: (20 / 2.5)² = 64. Pressure is equal on both pistons, so your push is the weight ÷ 64: 1,500 × 9.81 ÷ 64 ≈ 230 N.
- Volume in = volume out: A₁·d₁ = A₂·d₂. The big piston has 64× the area, so you push 64× as far: 64 × 0.10 m = 6.4 m, about 43 pumps of 15 cm.
- A narrower pump needs less force but more pumps: the force goes as d², the travel as 1/d². Only 1.7 or 1.8 cm satisfies both: (16/1.8)² ≈ 79 → 186 N and 53 pumps.
- Area ratio 64 → 128, so the push halves to ≈ 115 N. And the car now rises half as far per pump: 12.8 m of pushing for the same 10 cm.
- Work = force × distance YOUR hand moved: 230 N × 6.4 m ≈ 1,471 J, exactly m·g·h = 1,500 × 9.81 × 0.1. The jack multiplies force, never energy.
About the model
- Ideal jack: incompressible oil, no leaks, no friction at the seals or valves, massless pistons and handle; a check valve holds the car while the pump handle returns.
- Quasi-static lifting: the car rises slowly, so your push equals exactly M·g·A₁/A₂ (no extra force to accelerate anything). Pressure is the gauge pressure under the lift piston (atmospheric and the oil’s own weight ignored).
- Areas come from the diameters (A = π·d²/4), so the force ratio is (d₂/d₁)². Your push is applied straight down on the pump piston; real jacks add a lever handle that multiplies force again.
- Each pump pushes the small piston one full stroke (15 cm by default) in 0.6 s, then the handle returns in 0.3 s. The run ends the instant the car reaches its target height.
- The 3D view is schematic: the pump piston is drawn at least 7 cm wide so it stays visible (so the drawing understates the real area ratio), the car is an abstract block, and force arrows are on a log scale (14.7 kN would be 100× longer than 147 N).
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.