What you’ll explore
One pack gets hot, one gets cold. Where does the heat go? In this lab you squeeze an instant cold pack and a hot pack and test your intuition against a real physics simulation.
Challenge levels
- Hot or cold?. You squeeze a pack of 30 g ammonium nitrate (NH₄NO₃) into 100 g of water at 20 °C. Does the water get warmer or colder? Type +1 for warmer, −1 for colder.
- How cold does it get?. Same pack, perfectly insulated: 30 g NH₄NO₃ (80.0 g/mol, +25.7 kJ/mol) dissolves completely in 100 g of water. Take the whole solution as 130 g with c = 4.18 J/(g·°C). What is the temperature change, in °C?
- Make it 40 °C. Now a hot pack: calcium chloride (CaCl₂, 111 g/mol, −82.8 kJ/mol) in 100 g of water at 20 °C, insulated. Choose the mass of CaCl₂ so the pack ends at 40 °C (± 0.6 °C).
- What if: twice the water. Back to the cold pack: 30 g NH₄NO₃, insulated, but now in 200 g of water. What is the temperature change now, in °C?
- Real-world check: a hot pack in your hand. A real hot pack is not insulated: 30 g CaCl₂ in 100 g of water at 20 °C loses heat to your hand and the air at 0.5 W per °C above 20 °C. It dissolves with τ = 15 s. What is the hottest it gets, in °C?
Key ideas
Show the explanations (spoilers: try the levels first)
- Dissolving NH₄NO₃ is endothermic (ΔH = +25.7 kJ/mol). The energy to break up the crystal comes out of the water’s own motion, so the water gets colder. That is exactly how an instant cold pack works.
- n = 30 / 80.04 = 0.375 mol, so the salt takes 0.375 × 25,700 = 9.63 kJ. The solution needs 130 g × 4.18 = 543 J for each degree, so ΔT = −9,632 / 543 ≈ −17.7 °C.
- You need a 20 °C rise: (100 + m) × 4.18 × 20 joules. Each gram of CaCl₂ releases 82,800 / 111 = 746 J, so m × 746 = (100 + m) × 83.6, giving m ≈ 12.6 g. A little salt goes a long way.
- Same heat (9.63 kJ), but 230 g of solution now needs 961 J per degree: ΔT = −9,632 / 961 ≈ −10.0 °C. Roughly half, not exactly half, because the 30 g of salt is part of the mass too.
- Insulated, the pack would reach 20 + 41.2 = 61.2 °C. Heat starts leaking out as soon as the pack is warm, so the curve peaks about a minute in at ≈ 58.8 °C and then slowly cools. Commercial CaCl₂ hot packs are rated around 50–60 °C.
About the model
- Enthalpies of solution at 25 °C: NH₄NO₃ +25.7 kJ/mol (endothermic), CaCl₂ (anhydrous) −82.8 kJ/mol (exothermic; tables give −81 to −83 kJ/mol). Molar masses 80.04 and 110.98 g/mol. ΔH is taken as constant over the temperature range.
- Calorimetry: the whole solution (water + salt) is given c = 4.18 J/(g·°C), the usual classroom approximation. Real concentrated solutions have a somewhat lower specific heat, which would make the temperature change a little larger.
- Dissolving is modeled as first order, fraction dissolved f = 1 − e^(−t/τ) with τ = 15 s by default; real packs dissolve unevenly and depend on grain size and mixing.
- Heat exchange with the surroundings follows Newton's law, h·(T − T₀), with the surroundings at the starting temperature T₀ (h = 0 means perfectly insulated). The pack itself (plastic) has no heat capacity. With h > 0 the equation has an exact solution, so the curve and the peak are closed form.
- Real-world check: commercial instant cold packs typically cool to a few °C above freezing and CaCl₂ hot packs are rated around 50–60 °C, consistent with the 30 g-in-100 g packs here (≈ 3 °C and ≈ 59 °C with 0.5 W/K of heat loss).
- The sandbox allows combinations beyond real solubility or boiling (for example 80 g CaCl₂ in 20 g of water); the model does not stop at 100 °C or at saturation.
- Pack drawings are schematic: salt grains shrink as they dissolve and the color follows the temperature; arrows show the direction of heat exchange with the surroundings, not its exact size.
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.