What you’ll explore
Can you hit exactly 60 rpm in 3 seconds? In this lab you spin up a bicycle wheel to a target speed and test your intuition against a real physics simulation.
Challenge levels
- Hit 60 rpm in 3 s. Challenge: choose the drive torque so the bicycle wheel spins at exactly 60 rpm (±1) when the 3 s are up. Bearing friction is 0.05 N·m.
- How many turns?. With that torque the wheel goes from rest to 60 rpm in 3 s. How many full revolutions does it make on the way?
- Net torque. Drive torque 1.00 N·m, bearing friction 0.05 N·m, I = 0.2205 kg·m². What is the angular acceleration, in rad/s²?
- What if it’s a disc?. Same mass (1.8 kg), same radius, same torque as the 60 rpm run, but the wheel is a solid disc instead of a hoop. What spin does it reach at 3 s, in rpm?
- Pulled toward the axle. At the end of the 60 rpm run, how big is the centripetal acceleration of a point on the rim (R = 0.35 m), in m/s²?
Key ideas
Show the explanations (spoilers: try the levels first)
- 60 rpm = 2π rad/s. Reaching it in 3 s needs α = 2π/3 ≈ 2.09 rad/s². Net torque = Iα = 0.2205 × 2.09 ≈ 0.46 N·m, plus 0.05 N·m to beat friction: about 0.51 N·m.
- θ = ½αt² = ½ × 2.09 × 3² ≈ 9.42 rad = 1.5 rev. Speeding up evenly, the average spin is half the final 1 rev/s.
- α = (τ − τf)/I = 0.95 / 0.2205 ≈ 4.31 rad/s². Ignoring friction gives 4.54, too high.
- I(disc) = ½MR² is half of I(hoop) = MR². Same net torque → twice the angular acceleration → 120 rpm at 3 s.
- a_c = ω²R = (2π)² × 0.35 ≈ 13.8 m/s², almost 1.4 g, while the speeding-up part αR is only 0.73 m/s².
About the model
- Bicycle wheel on a test stand: 1.8 kg, R = 0.35 m, treated as a thin hoop (I = MR² = 0.2205 kg·m²); spokes and hub mass are ignored. The what-if disc is a uniform solid disc (I = ½MR²) of the same mass and radius.
- The drive torque is constant. Bearing friction is a constant 0.05 N·m torque that opposes the spin; from rest the wheel only turns if the drive exceeds it (static friction holds it otherwise). Air drag is ignored.
- α = (τ − τf)/I, ω = ω0 + αt, θ = ω0t + ½αt². With the drive off, friction slows the wheel at a constant rate and it stops exactly at t = ω0/|α|, then stays still.
- Rim point: speed v = ωR, tangential acceleration αR, centripetal acceleration ω²R. Arrows are scaled per run to stay readable (not to a fixed scale).
- The coast-down segment starts with the wheel already spinning at 60 rpm (the documented moving-start exception).
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.