What you’ll explore
Push near the hinge and the door barely moves. Why? In this lab you open a heavy door: push at the handle vs near the hinges and test your intuition against a real physics simulation.
Challenge levels
- Push the handle. You push the handle, 0.85 m from the hinge, with 20 N straight into the door. What torque do you make, in N·m?
- Near the hinge. At the door’s edge (0.9 m from the hinge) a 20 N push does the job. Push 0.1 m from the hinge instead: how many times more force do you need for the same torque?
- Best angle. You push the handle with 20 N but can choose the angle between your push and the door. Find the angle that gives the most torque (within 0.1%).
- Open it in a second. You can push with 25 N. Where do you have to push so the 25 kg door swings open to 90° within 1.0 s?
- How much slower?. At the handle (0.85 m) a 20 N push opens the door to 90° in 1.12 s. Same push at 0.1 m from the hinge: how long does it take, in seconds?
Key ideas
Show the explanations (spoilers: try the levels first)
- Torque = r × F × sin φ = 0.85 m × 20 N × 1 = 17 N·m.
- Same torque means r × F stays the same: 0.9 × 20 = 0.1 × F, so F = 180 N, nine times more.
- Only the part of the push perpendicular to the door turns it: τ = rF·sin φ is largest at φ = 90°. At 30° you get half the torque.
- θ = ½αt² with α = rF/I. Reaching π/2 in 1 s needs α = π rad/s², so r = πI/F = π × 6.75 / 25 ≈ 0.85 m: push near the edge.
- θ = ½αt² gives t = √(2θ·I/τ). With 8.5× less torque the time grows by √8.5 ≈ 2.9: 1.12 s → 3.26 s.
About the model
- Door = uniform slab, 25 kg, 0.9 m wide, turning about its hinge: I = ⅓ML² = 6.75 kg·m². Hinge friction and air resistance are ignored.
- The hand pushes with a constant force and follows the door, keeping the same angle φ to its surface, so the torque τ = r·F·sin φ stays constant and α = τ/I.
- The door stops at a 90° door stop (the hand lets go there); a door that never reaches 90° is shown for 6 s.
- Door closer (what-if): a light torsion spring K = 12 N·m/rad with a damper C = 8 N·m·s/rad. Real closers use a rack-and-pinion and hydraulic valves; the torques are of the same order.
- Motion is solved in closed form (constant torque, or a damped spring with constant torque), so results do not depend on the time step.
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.