What you’ll explore
At what angle does the box start to slide? In this lab you raise the angle until the box slides and test your intuition against a real physics simulation.
Challenge levels
- Breaking point. A wooden box sits on a wooden ramp (μs = 0.5). You raise the ramp slowly. At what angle, in degrees, does the box start to slide?
- Ten times heavier. Same wood, but the box is now 20 kg instead of 2 kg. How many degrees EARLIER than the 2 kg box does it slip? (Type 0 if it slips at the same angle.)
- Sliding down. Now the ramp is fixed at 35° and the box slides (μk = 0.3). What is its acceleration down the ramp, in m/s²? (g = 9.81 m/s²)
- One-second slide. Set the ramp angle so the box slides the full 2 m in 1.00 s (wood on wood: μs = 0.5, μk = 0.3).
- Pick the surface. Design a surface pair that holds the box until exactly 35°, then lets go. Choose the static friction coefficient μs.
Key ideas
Show the explanations (spoilers: try the levels first)
- The box slips when mg sinθ is more than μs·mg cosθ, which means tanθ > μs. tanθ = 0.5 gives θ ≈ 26.6°.
- It slips at the same 26.6°. Weight along the slope (mg sinθ) and the friction limit (μs·mg cosθ) both scale with m, so m cancels out of tanθ = μs.
- a = g(sinθ − μk cosθ) = 9.81 × (0.574 − 0.3 × 0.819) ≈ 3.22 m/s².
- To cover 2 m from rest in 1 s you need a = 2L/t² = 4 m/s². Solve 9.81(sinθ − 0.3 cosθ) = 4: θ ≈ 39.7°.
- The slip angle obeys tanθ = μs, so μs = tan 35° ≈ 0.70 (about rubber on wet concrete, or steel on steel).
About the model
- Coulomb friction: static friction matches the pull along the slope up to μs·N; once sliding, kinetic friction is μk·N (μk ≤ μs is enforced). g = 9.81 m/s².
- Surface pairs (typical textbook values, dry): wood on wood μs ≈ 0.5, μk ≈ 0.3; μs ≈ 0.7 is roughly rubber on wet concrete or dry steel on steel. Real values vary with surface finish and moisture.
- Raise mode: the ramp tilts at a steady rate and stops rising the instant the box slips (like a hand stopping). The slip is found in closed form at tanθ = μs, not by stepping.
- The box is a point mass sliding without tipping or rolling; no air resistance. It slides from rest the full ramp distance and the run ends when it reaches the bottom (the HUD then shows its arrival speed).
- Free-body arrows are drawn to scale: 1 m of arrow per the box weight (mg). Weight = amber, normal = blue, friction = teal.
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.