What you’ll explore
Cut the string. Which way does it fly? In this lab you cut the string mid-spin and test your intuition against a real physics simulation.
Challenge levels
- How hard does the string pull?. A 0.2 kg ball spins on a 0.8 m string at 3 m/s. What is the tension in the string, in newtons?
- Which way does it fly?. Cut the string. What angle does the ball’s path make with the string’s direction (the line from the peg out to the ball), in degrees?
- Hit the mark. The ball spins counterclockwise from the right-hand side of the table. Choose when to cut (how far it has turned) so it hits the mark on the far-left edge.
- What if: twice as fast. Same ball and string, but now at 6 m/s instead of 3 m/s. What is the tension now, in newtons?
- A 1.2 m throw. Choose the string length so that, after the cut, the ball flies exactly 1.2 m (±0.02 m) to the table edge (table radius 1.6 m).
Key ideas
Show the explanations (spoilers: try the levels first)
- To keep turning, the ball needs a force toward the center: T = m·v²/r = 0.2 × 3² ÷ 0.8 = 2.25 N. The string supplies it.
- At the cut the ball is moving along the tangent, at 90° to the string. With no force left, it keeps that velocity: a straight line along the tangent, at the same speed.
- The ball flies along the tangent, so it reaches the edge 60° further round than where you cut (tan 60° = 1.39 m ÷ 0.8 m). Cut at 120° to land at 180°.
- T = m·v²/r: twice the speed means four times the tension, 9 N. That is why a fast spin can snap a string that easily held a slow one.
- The tangent is at right angles to the string, so flight² + r² = R²: r = √(1.6² − 1.2²) ≈ 1.06 m.
About the model
- Top view of a frictionless horizontal table (radius 1.6 m) with a peg at the center. Gravity is balanced by the table, so the only horizontal force is the string tension, T = m·v²/r toward the peg.
- The ball is already spinning at constant speed when the clock starts (steady uniform circular motion), counterclockwise from the +x side. The string is massless and inextensible; the cut is instantaneous.
- After the cut no horizontal force acts: the ball moves in a straight line along the tangent at the same speed until it reaches the table edge (air drag ignored). The run ends at the edge.
- The dashed gray line (shown after the cut) is the common misconception, "straight out along the string", for comparison; it is not a possible path.
- Arrows: velocity (teal) 0.12 m per m/s; the string force (amber) is drawn toward the peg with a fixed length, its size is in the HUD. The ball is drawn larger than a real ball for visibility.
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.