What you’ll explore
Clear the bar with your center of mass below it? In this lab you the Fosbury flop and test your intuition against a real physics simulation.
Challenge levels
- How high does the CM go?. A jumper leaves the ground with the center of mass (CM) 1.20 m up, moving upward at 4.2 m/s. How high does the CM rise, in meters?
- Under the bar. Same jump, full arch, bar set as high as this flop can clear. When the hips cross, how many centimeters BELOW the bar is the CM? (Answer as a positive number.)
- Arch to clear. This jump lifts the CM to only 2.10 m. Set the arch so the body clears a 2.15 m bar.
- What if: scissors. Before 1968, most jumpers went over sitting upright (the scissors). For the highest bar a scissors jump can clear, how many centimeters ABOVE the bar must the CM pass?
- Take off at the right spot. Full arch, bar at 2.20 m. Choose how far in front of the bar to take off so the hips cross it near the top of the jump.
Key ideas
Show the explanations (spoilers: try the levels first)
- Whatever the arms and legs do, the CM moves like a thrown ball. It rises vy²/(2g) = 4.2² ÷ 19.62 ≈ 0.90 m, to 2.10 m.
- The arched body drapes over the bar: head and trunk hang down on one side, legs on the other, so the CM sits about 23 cm below the hips, while the back only needs about 11 cm above the bar. The CM passes about 12 cm under it.
- A flat body needs its back over the bar, so the CM must pass above it. Arching lowers the CM relative to the hips; from about half arch the hips clear 2.15 m while the CM stays near 2.10 m.
- Upright, the trunk and head sit on top of the hips, so the CM is about 21 cm above them, plus 9 cm to the bottom of the seat: about 30 cm above the bar. The same take-off clears 1.79 m with a scissors, 2.22 m with a full-arch flop.
- The CM path is fixed at take-off. Too close and the hips reach the bar while still rising; too far and they arrive on the way down. The sweet spot is about vx·vy/g ≈ 1.7 m out.
About the model
- The jumper is 5 rigid segments (head; upper trunk with the arms folded in; lower trunk; both thighs; both shanks and feet) with de Leva (1996) mass fractions. Each segment is a uniform rod, so its CM is at its middle. Total mass 70 kg, height about 1.77 m.
- After take-off only gravity acts, so the CM follows an exact projectile parabola from the take-off height (1.20 m) and speed. The body shape never changes the CM path; the body turns about the CM at a constant rate (no torque about the CM). The run starts at the moment of take-off, already moving.
- The posture is held fixed during the flight (a real jumper arches progressively). The flop arch bends the trunk down 30–100° toward the head and the legs down 35–110° (bent knees) from the hips; the scissors sits upright with the legs straight out.
- Clearance is judged when the hips are directly over the bar with the body level: the body is a tube 9 cm in radius around its centreline (hips to back surface), and the highest clearable bar is where that tube just touches it. Assumes the body rolls over the bar so the part crossing it is the top of the arch — what the technique is designed to do.
- Idealised numbers: with a full arch the CM passes about 12 cm under the bar. Measurements of elite jumpers (e.g. Dapena) usually put the CM close to or a few cm below the bar; real bodies are not a perfect arch.
- The landing ends the run when the CM is back down to 0.95 m (lying on a 0.7 m mat). Speeds: 4 m/s forward, 4.2 m/s up (typical for club-level jumpers; elite about 4.5–5 m/s up).
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.