What you’ll explore
Hit it off-center. Why do they split at 90°? In this lab you off-center pool shot and test your intuition against a real physics simulation.
Challenge levels
- The split. The cue ball (1.5 m/s) clips the object ball 20 mm off-center. What angle is there between the two balls’ paths after the hit, in degrees?
- Half-ball hit. Now aim so the cue ball’s center points at the object ball’s edge (b = r = 28.6 mm). At what angle from the cue’s line does the object ball leave, in degrees?
- Who gets the speed?. Same half-ball hit at 1.5 m/s. How fast does the object ball leave, in m/s?
- Pot it. The object ball sits on the center line, 0.635 m from the bottom-right corner pocket. Choose how far off-center to hit it so it drops into that pocket.
- What if the balls aren’t perfect?. Real balls lose a little energy: e = 0.9 instead of 1. Half-ball hit again. What is the split angle now, in degrees?
Key ideas
Show the explanations (spoilers: try the levels first)
- Momentum: p = p₁ + p₂. Energy (equal masses): p² = p₁² + p₂². Both can only be true if p₁ and p₂ are at right angles — so the balls always split at 90°.
- A smooth ball can only push along the line joining the two centers. At contact the centers are 2r apart and b = r off-line, so sinθ = r / 2r = ½ → the object ball leaves at 30°, and the cue ball at 90° to it (60° the other way).
- The velocities make a right triangle with the 1.5 m/s cue speed as the long side: object 1.5 × cos 30° ≈ 1.30 m/s, cue 1.5 × sin 30° = 0.75 m/s.
- Aim the line of centers at the pocket. The pocket is 45° off the cue’s line, so b = 2r × sin 45° ≈ 40.4 mm. (The cue ball then leaves at 45° the other way — watch it head for the top-right corner!)
- With e < 1 the object ball gets a bit less push along the line of centers, so the cue ball keeps a little forward motion and the angle drops to about 85°. Real pool balls (e ≈ 0.93) split a few degrees under 90°.
About the model
- Top view of a 9-ft pool table (2.54 × 1.27 m playing surface). Two equal balls: 57.15 mm diameter, 170 g. The cue ball is already rolling when the clock starts; the object ball is at rest.
- The balls are smooth and slide without friction: no spin, no rolling, no throw. The hit is instantaneous and pushes only along the line joining the centers, with restitution e (e = 1 perfectly elastic; real pool balls ≈ 0.93).
- After the hit, the object ball moves along the line of centers at v·cosθ and (for e = 1) the cue ball at v·sinθ, perpendicular to it, where sinθ = b / 2r. On a real table rolling and spin bend the cue ball’s path afterwards (follow and draw); that is not modeled.
- Rails are not modeled as bounces: a ball that reaches a rail stops there. If that point is within a pocket mouth (6 cm of a corner, 5.5 cm of a side pocket), the ball counts as potted.
- The split angle and ball directions are measured from the balls’ motion (their displacement since the hit). The momentum and energy readouts are taken just after the hit. The triangle panel draws the momenta head-to-tail.
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.