What you’ll explore
Two springs are stiffer… or softer? It depends how you hang them. In this lab you hang a weight on two springs side by side, then end to end and test your intuition against a real physics simulation.
Challenge levels
- Side by side. One spring (k = 50 N/m) stretches 19.6 cm under 1 kg. Hang the same 1 kg on TWO such springs side by side. How far do they stretch, in m?
- End to end. Now hang the same 1 kg on the two springs joined end to end (one below the other). How far does the pair stretch in total, in m?
- Build a 40. The top spring is fixed at k₁ = 60 N/m. Choose the bottom spring k₂ so the end-to-end pair behaves like a single 40 N/m spring (±0.5 N/m, judged from where the 1 kg hangs).
- What if they bounce?. Pull both pairs of identical springs down 5 cm and let go. How many times longer is one end-to-end bounce than one side-by-side bounce?
- Force in the chain. The 1 kg hangs still on the end-to-end pair. What force (in N) does the TOP spring carry?
Key ideas
Show the explanations (spoilers: try the levels first)
- Side by side the two springs act like one spring of k = 50 + 50 = 100 N/m: s = m·g / k = 9.81 / 100 ≈ 0.098 m, half the single spring.
- Each spring carries the full 9.81 N and stretches 19.6 cm; together 39.2 cm. The chain acts like one spring of k = 50·50/(50+50) = 25 N/m.
- In series the softnesses add: 1/k = 1/k₁ + 1/k₂. For 1/40 = 1/60 + 1/k₂ you need k₂ = 120 N/m. A series pair is always softer than its softest spring.
- Side by side k = 100 N/m, end to end k = 25 N/m: four times softer. T = 2π√(m/k), so the end-to-end bounce is √4 = 2 times longer (1.26 s vs 0.63 s).
- The top spring holds everything below it: the full 1 kg × 9.81 = 9.81 N (the springs themselves are massless). Side by side, each spring would carry only half, 4.9 N.
About the model
- Ideal massless springs obeying Hooke’s law, 0.20 m free length each; no damping or air drag, so the bounce never dies down.
- Side by side (parallel): a light bar joins the two springs so they stretch equally; the bar is kept level (the mass hangs at the point where the torques balance), so k = k1 + k2.
- End to end (series): a light plate joins the springs; because it is massless it always sits where both springs pull equally, so 1/k = 1/k1 + 1/k2. A real junction with mass would add a faster, tiny wobble.
- Each mass is pulled down A below where it hangs and released from rest: x(t) = A·cos(ωt), ω = √(k/m), exact at every time step. The HUD shows each rig’s total stretch (from the free length) and its period.
- Levels read the stretch from the middle of the bounce and time the period from the motion itself, like a ruler and a stopwatch. Masses and spring thickness are drawn larger than real for visibility.
Every number on screen comes from the simulation, and each lab passes automated checks against the physics formulas. Spotted a mistake? Tell us.